|
07-21-2018, 08:00 PM
|
#1 |
|
Not Yet Wild
Join Date: Jun 2018
Posts: 11
|
Using stock clutch on clone
Putting in duromax 16 hp in g2. Going to use stock clutch. I have adapter for it. Mighty long bolt. The shaft part that sticks out is 2.75 inches. I know it needs to be cut down, drilled, and I tapped. Any advice, help on it. If I remove the shaft and take it to shop what am I looking at as far as doing that.
|
|
|
| Tags |
| clone, clutch, stock |
|
||||||
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Comet 780 or stock clutch on clone swap | Clone Engine Swaps | |||
| Clone 3A and stock generator? | Clone Engine Swaps | |||
| What Taper on Stock ClubCar clutch (Specs for clone engine) | Clone Engine Swaps | |||
| 88 stock clutch going on a 16hp clone | Big Block Talk! | |||
| Honda clone with stock clutch on a CC | Big Block Talk! | |||
Threaded Mode