|
06-17-2020, 03:44 PM
|
#21 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 22
|
Re: Help with club car please
Thank you I have a shop local that sells the oem coil. So I will get it here it’s $95
I’ll update after this Pain in the *** repair. |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
06-25-2020, 07:50 PM
|
#22 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 22
|
Re: Help with club car please
Ok guys I have the coil and disassembled everything except one last bolt on the shroud that is dead against a the entire engine plat on the rear! How the heck do I get this out without moving the engine forward? Has anyone done this job Jesus Christ man this sucks. One bolt!
|
|
|
|
|
06-25-2020, 08:31 PM
|
#23 |
|
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Help with club car please
I just pull the motor out, 25minutes and its in your hand. Makes it easy to set the air gap, clean it up a bit.
|
|
|
|
|
06-25-2020, 09:11 PM
|
#24 |
|
Not Yet Wild
Join Date: Jul 2019
Location: Florida/Minnesota
Posts: 21
|
Re: Help with club car please
I disconnected the motor and moved it forward enough to get at it
|
|
|
|
|
06-25-2020, 09:33 PM
|
#25 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 22
|
Re: Help with club car please
Was hoping to avoid that but there is no other way thanks guys.
|
|
|
|
|
06-26-2020, 07:00 AM
|
#26 | |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 22
|
Re: Help with club car please
Quote:
|
|
|
|
|
|
06-26-2020, 07:43 PM
|
#27 |
|
Gone Wild
Join Date: May 2015
Location: Central Florida
Posts: 2,114
|
Re: Help with club car please
4 on the bottom, 2 in the back, then there are some other things you need to disconnect to get the motor completely out.
|
|
|
|
|
07-01-2020, 08:26 AM
|
#28 |
|
Not Yet Wild
Join Date: Apr 2015
Posts: 22
|
Re: Help with club car please
Thank you all for your help the ignition coil fixed it. Purchased an oem Kawasaki coil for $100 because I wasn’t planning on doing that job again anytime soon.
|
|
|
|
Linear Mode
