|
Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
|
Thread Tools | Display Modes |
11-27-2021, 12:33 PM | #1 |
Not Yet Wild
Join Date: Aug 2008
Posts: 57
|
Ezgo Marathon Won’t Move
I have a 36v Ezgo Marathon that I just put a brand new set of batteries in and the solenoid clicks when the pedal is pressed but the card will not move. After looking at the controller I found that the B+ and B- posts are getting hot and the resistor on the solenoid is too hot to even touch. Any thoughts on what is causing this and how to check it?
Thank you, Roy |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
11-27-2021, 02:28 PM | #2 |
Gone Wild
Join Date: Sep 2021
Location: Pa
Posts: 279
|
Re: Ezgo Marathon Won’t Move
What year is the cart ?
The solenoid getting hot is most likely poor internal contacts. Check the voltage on the load side, it should be pack voltage. Wires getting hot is usually a poor connection. Pull them apart, clean them and make sure they are tight. |
11-27-2021, 02:42 PM | #3 |
Not Yet Wild
Join Date: Aug 2008
Posts: 57
|
Re: Ezgo Marathon Won’t Move
Thanks for the reply. This is 1993 Marathon.
|
11-27-2021, 05:36 PM | #4 |
Not Yet Wild
Join Date: Aug 2008
Posts: 57
|
Re: Ezgo Marathon Won’t Move
I tried it again and the solenoid itself is not heating up. Only the small resistor between the two main studs on the solenoid. Still not working
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Ezgo marathon wont move | Electric EZGO | |||
'91 Ezgo Elec Marathon-won't move | Electric EZGO | |||
EZGO Marathon Won't Move | Electric EZGO | |||
1993 ezgo marathon controller cart won't move | Electric EZGO | |||
Ezgo Marathon will not move | Electric EZGO |