New source of V-Twin performance parts!

[shawn.m]

I was reading on the Heymow.com forum about a competitor to Al Hodge at http://www.performancevtwins.com/

It is http://www.eccarburetors.com/
When I talked to one of the counter guys this morning. He gave me a recipe to get 50hp plus out of the 18-20hp briggs. of course your talking almost $3k on top of your $1 motor.

Low buck $410 I am already halfway there! - just need the cam and thin head gaskets
16hp heads $75
Thin head gaskets $40
Precision cam $175
Rev kit $75
K&N air filter $35
Rejet carb $10 for jets


mid buck build maybe 40hp $1500
ARC billet aluminum flywheel for starters. $320 http://www.arcracing.com/cgi-bin/Sof...exe/?E+scstore
Starter to go with flywheel $175
Precision Camshaft cost about $175
Modified carb $175 up from EC Distributing
Air cleaner & adapter $150
Roller rockers $300 - if you have the good aluminum rockers you wont need these.
Port & polish heads $150
ARC rods $220 http://www.arcracing.com/cgi-bin/Sof...exe/?E+scstore
Thinner head gaskets $35

Also a interesting point was to bolt 16hp heads on a 18-20hp motor to pick up some compression

High end build 60hp build! will run at 7000 rpm at the race track!
$3000
Cam 1200 Precision
Longer than stock Rods 229.00 ARC or 225.00 E.C.
Using the longer rods you cut the stock pistons 100 thousands creating flat tops and more compression. 30.00 new rings E.C. 29.00 a set.
Now outside several options. 16hp heads again smaller chamber and more compression
new unported E.C. 150.00 ea. ported and all the works, springs and retainers 300.00 ea.
Used I have several sets stock 75.00 ea.
ported and all my magic touch including dual springs and billet retainers 200.00 each
Billet flywheel 345.00 E.C.
High torque Starter 160 E.C.
two steel push rods to replace aluminum E.C. 4.50 ea.
have that carb built to the hilt to run that beast could run as high as 700.00 depending on level of build.
K&N Airfilter E.C. 42.95
Air filter adapter 39.95
Roller rockers Performance V-twin 325.00 Thats all I would recommend you buy there.
K&N filter for crank case breather 12.95
Gasket set to include very thin aluminum gaskets (more compression) E.C. 48.00

[shawn.m]

oh yeah custom cam grinds
http://www.precisioncams.com/

[todwil]

Yea Performance V-Twins is where I get my stuff they even make parts
for the bigger blocks 31hp-35hp vanguards!!!!