Bandsaw Table.

[dundeebarnbuggy]

While most of my shop projects would have little interest here, I did finish a table for a portable bandsaw that would work nice in even a small garage or even in the kitchen if that's all the space you have for working. A piece if 3/8 x 8" plate was the basis for the top with some bits of angle and square tubing for legs. A router control mounted underneath at the front gives me on/off and if needed variable speed at my fingertips. I did plane the whole works after it was done to get the table dead flat and smooth again so stock slides easily. A little trimming of the blade on an old Craftsman miter gauge as it fit a little too tight in the slots. A quick sandblast of the underside and legs, some paint and done.

[Swan]

very nice , oh by the way, I need to borrow that

[TheNewGuy]

Nice work! Good idea.