|
|
|||||||
| Electric EZGO Electric EZ GO Marathon, Medalist, TXT and RXV. |
  |
|
|
Thread Tools | Display Modes |
03-30-2012, 08:55 PM
|
#1 |
|
Not Yet Wild
Join Date: Jan 2012
Location: Tidewater, VA
Posts: 22
|
Battery cable question
When doing routine maintenance on my batteries cleaning them and spraying terminal protectant on them. I noticed that one of the cables the insulation is pulled back away from the connector. Is there anything I should wrap this cable in to keep it from being exposed. It is pulled back about 1/4 to 1/2 an inch. I wasn't sure if the 36 volt would create too much heat and I would be better leaving it alone. I plan on going with a new set of heavier cables in the future. I just want to know the best way to take care of it for the time being. Any suggestions would be appreciated.
|
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
03-30-2012, 08:58 PM
|
#2 |
|
Stay thirsty my friends!
 Join Date: Jan 2007
Location: Suburban Chicago
Posts: 24,284
|
Re: Battery cable question
You could slide an inch of shrink tubing over it. Better than electrical tape anyday.
|
|
|
|
|
03-30-2012, 09:25 PM
|
#3 |
|
Not Yet Wild
Join Date: Jan 2012
Location: Tidewater, VA
Posts: 22
|
Re: Battery cable question
Thanks for the info.
 |
|
|
|
|
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| battery cable question | Electric Club Car | |||
| Battery cable question | Electric EZGO | |||
| Battery cable upgrade question | Electric EZGO | |||
| battery cable question | Electric Club Car | |||
| Battery Cable Question | Electric golf carts | |||
Linear Mode
