Should I check motor ? series model

[trig123]

Originally Posted by Cartmaster

That's just dumb. If it were me and I had the body off, first thing I would be doing is checking the motor brushes and commutator along with any bearings. Last thing you want on a 1996 cart is to put the body back on and a few weeks down the line, trying to pull the motor cos the brushes are worn. Better to learn how now, than later. Come on Trig, I know you can do it!

I will try and get if off. I know I can do it but being I hurt my back again a few weeks ago I can't lift very much.
If I remove the three bolts to remove it then set it on bench this is how I read to do it.
The problem is mine has four bolts on the can end but I would think it would be the same.

From an older post way back in 2010 when I was much younger

Once you get it off there will be 2 bolts on the can end. Take those out, set the motor on the can end and slip the outer case off OVER the armature. Leave the armature there. You'll then see the brushes and holder assembly
Is this how I do it ? because like I mentioned I see four bolts on the can end. I think unless I didn't look good