|
Gas Yamaha Gas Yamaha Golf Cars; G1 through "The Drive" and U-Max Utility Vehicles |
|
Thread Tools | Display Modes |
09-25-2011, 08:09 AM | #11 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: want to put lift kit on yomaha g16 is it a big job
After taking a voltage reading at the batt. (12.4 or what ever it reads), then start the car, rev it up somewhere around half throttle, and take another reading at batt. The voltage should be higher,(in the 13's or 14 volts range). If it is higher, the generator is charging the batt.
If it is charging over, or close to 16 volts, the voltage regulator may need adjusted or replaced. Unless the batt is very low on charge. But as it charges, voltage should come down to 13. something. |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
10-02-2011, 07:39 AM | #12 |
Not Yet Wild
Join Date: Sep 2011
Location: cincinnati ohio
Posts: 49
|
Re: want to put lift kit on yomaha g16 is it a big job
i took a reading at the batt before and then after @ half trottle not much difference on my voltmeter
|
10-02-2011, 08:02 AM | #13 |
G8 Specialist
Join Date: Jun 2009
Location: Phoenix
Posts: 7,799
|
Re: want to put lift kit on yomaha g16 is it a big job
But was it higher? Maybe the battery had a full charge, and was not accepting a charge. Is the battery still running down?
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Which is a better lift kit? Allsports or Jakes for 6" lift. | Lifted Golf Carts | |||
Is Strecth Plastic LT lift a good Lift for EZ GO | Lifted Golf Carts | |||
Spindle Lift Added To Drop Lift | Gas EZGO | |||
Axle lift vs. Spindle lift- Pros and Cons | Lifted Golf Carts | |||
Axle lift vs. Spindle lift- Pros and Cons | Electric EZGO |