![]() |
|
Gas EZGO Gas EZGO Marathon, Medalist, TXT and RXV. |
![]() ![]() |
|
Thread Tools | Display Modes |
|
![]() |
#1 |
Not Yet Wild
Join Date: Nov 2011
Posts: 73
|
![]() So The old girl has been slowly dieing. Compression was 90 in forward and 85 in reverse.Ran it like that for well over a year now.Seemed to work fine. Start fine .etc. The other night on a suds run it seemed to just slow down and just die. Thaught it was out of fuel. pushed her the rest of the way to the building and topped her up. It did start but didnt like it. So called it quits for the night. Next day checked the filter and it was empty. The pump wouldnt fill it up. Pulled the line off and filled it with a syringe. It ran for a bit and died again.Checked the crank seals but they seemd fine. So I pulled the pump and cleaned it out. Blew the line from the tank back. No problem there. Cranked it with the pump off and seemed to blow out the hole in the bottom end fairly well.Put the pump back on and tryed again. No go. So tryed the compression for fun again. 75 both ends this time. Next I think i will try is pull the carb off and give it a good strip and clean . I know I should just quit and fix the compression problem but whats the worst I can do. Will the fuel pump run on that low of compression? Any other ideas is greatly welcome. I miss the old green machine not runnnin. We use it alot.
![]() |
![]() |
![]() |
![]() |
#2 |
Hammer Down !!!!
![]() Join Date: Jun 2010
Location: Lake Geneva, WI
Posts: 2,681
|
![]() The pump runs of crankcase pressure, not compression - and it seems you have that going for You. What you also did (other than likely running out of gas which started the trouble) was pull the fuel lines and blew them clean, which likely GURANTEED that you lost the prime (these older 2-stroke pumps hate to self-prime) ...
Pull the fuel line going OUT of the pump, then open the gas tank. Wrap a rag around the filler neck to create a seal, and either blow into the tank to pressurize fuel up into the pump or do it extremely carefully with an air gun at low pressure (if using an air gun it's prob easier to use the cleanout bung - smaller hole to seal) Give it a shot - its free, fast and easy |
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
Fuel problem??? | Gas Yamaha | |||
2pg fuel problem | Gas EZGO | |||
G-16 fuel problem | Gas Yamaha | |||
fuel problem | Gas EZGO | |||
93 marathon fuel problem | Gas EZGO |