03-22-2023, 07:36 PM | #1 |
Not Yet Wild
Join Date: Apr 2014
Posts: 19
|
Western
Hello to you all here! I got a strange problem. I got a 1990 western 42 volts. All new batteries and have I think 44 volts at pack. It's ran great, but it sat 3 days and now If I hold pedal down after solenoid click for 6 to 10 seconds it will go, and run 22 mph. Now it sat a day, batteries fully charged as always. Solenoid clicks in forward and reverse. No movement. It has a 1206-04 controller with 4 post and 5 pin plug in. I'm guessing it's the controller. I swapped the solenoid out. Changed the f&r switch. It has nice 2 awg wires. So I'm stumped!! Plz help! Thanx in advance for any reply! Happy days to all..!
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-24-2023, 08:22 AM | #2 |
Not Yet Wild
Join Date: Apr 2014
Posts: 19
|
Re: Western
Well I found out that if I disconnect the neg- battery for a few minutes it will run again. Of course it will stop running in a few hrs after running,and sitting. Just a solenoid click but no movement. Any ideas Guy's? Thanx mucho!
|
04-03-2023, 04:21 PM | #3 |
Not Yet Wild
Join Date: Apr 2014
Posts: 19
|
Re: Western
Hello, guys! Need some advice plz.., My Powerwise 36 volt G01 charger comes on fine. Then in 20 seconds it shuts off. Keeps doing that. It has a new Capacitor, and new relay I put on the control board. I installed the relay cause when I bypassed it, then it would come on. Now it comes on but shuts off in 20 seconds. Batteries are new, and have 37 volts on the pack. Diodes test 540 oms each in one direction. Do you think total board is bad? I'm stumped. Any help, Appreciated! Thanks
|
|
|
Similar Threads | ||||
Thread | Forum | |||
Preparing list for Western and Mid-Western US reprogrammimg trip. | Electric EZGO | |||
My Western 300 | Members Rides | |||
EZ-G-O (Western) | Electric EZGO |