Primary drive sleeve

[Myyke]

Here is a pic of what i had gotten made up for a primary drive sleeve.
1.367”ID bearing OD is 1.368. Press fit bearing into sleeve.
1.48” seal face ID. 1.5” OD on the seal i used.
1.56” OD diameter of the primary sleeve. Used floating flange OD of 1.58”
1.00” wide. 1.03” Inner primary sleeve length.


Checked sleeve for fit in primary clutch first & clutch will slide easy over primary sleeve when motor revs up.

[Scooter_Trash]

Looking good, what type of lathe setup do you have?

[Myyke]

Originally Posted by Scooter_Trash

Looking good, what type of lathe setup do you have?

I don’t have one myself yet. I took it to a neighbor that has one. I’ve taken stuff to him before. Found out he didn’t have a boring bar, so all it cost me was the boring bar kit ($50) & a visit.

I’ll be buying my own lathe once i have a place for it in my garage. Have to finish a few projects to make room. Lol