![]() |
![]() |
#1 |
Gone Wild
![]() Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,563
|
![]() I don't recall seeing any post concerning what the temperature(s) of a leaf battery pack rise to during charging.
In previous charging to my leaf pack the ZEVA temp gauge usually shows about a 6 degree "hotter" than the ambient temperature at the time. Yesterday I charged the pack while the temp was 88 degrees and at the end of charging the pack temp showed 94 degrees. Now, I placed my hand on top of the pack and it felt slightly warm.....but not excessively warm. I think this is "normal" for the pack temp to rise above the room temp.....and I'm not alarmed about it, but I thought I'd toss out this subject should anyone else care to "toss in" their experiences of lithium charging details about heat. ![]() |
![]() |
![]() |
![]() |
|
![]() __________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
![]() |
#2 |
Just Gone
![]() ![]() Join Date: Sep 2015
Location: North Carolina
Posts: 3,549
|
![]() Mine does the same.
Temperatures are naturally going to go up while charging and also while being discharged. |
![]() |
![]() |
![]() |
#3 |
Not Yet Wild
Join Date: Nov 2018
Posts: 16
|
![]() mine does the same. I also check mine after a few miles of a cart ride, and I’ve never felt the pack or the cables much warmer than the outside temp.
I suppose when charging it depends on how many amps you are charging at. |
![]() |
![]() |
![]() |
#4 |
Not Yet Wild
Join Date: Jan 2021
Posts: 10
|
![]() It depends on the chemistry of the cell, but typically cell manufactures will list maximum temperature which is around 60-80degC (in my experience) before there is concern of thermal runaway. Not sure where the ZEVA temps sensors are located but I would give yourself some safety margin as the real cell temperature is likely above what is being reported.
|
![]() |
![]() |
![]() |
#5 |
Gone Wild
![]() Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,563
|
![]() I placed my ZEVA temp sensor in the middle of the 14 module pack.
I suppose if one of the module's were to get too hot, the ZEVA would not "know" this....but I still like the idea of a temp sensor. A better option would be to have a sensor in-between each module.....but that wasn't possible with the ZEVA. |
![]() |
![]() |
![]() |
|
Thread Tools | |
Display Modes | |
|
![]() |
||||
Thread | Forum | |||
Battery break-in and Motor temp question | Electric Club Car | |||
RXV Battery temp sensor | Electric EZGO | |||
EZGO RXV ... where can a buy a Temp block with wire ? (pos battery post end ) | Electric EZGO | |||
PowerDrive 3 charging temp high | Electric Club Car | |||
Temp battery usage | Electric Club Car |