lifted club cars - lifted ezgo
Home FAQDonate Who's Online
Go Back   Buggies Gone Wild Golf Cart Forum > Modified Golf Carts > Big Block Talk! > Clone Engine Swaps


Post New Thread  Reply
 
Thread Tools Display Modes
Old 05-26-2023, 07:52 PM   #11
raydhd
VC 460 CLONE GONE WILD
 
raydhd's Avatar
Yamaha
 
Join Date: Oct 2014
Location: Ray BY The Bay NJ
Posts: 10,386
Default Re: Cheap 420 cc engines

The single cylinder clones are in the archives section
raydhd is offline   Reply With Quote
Alt Today
BGW

Golf car forum Sponsored Links

__________________
This advertising will not be shown in this way to registered members.
Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum
   
Old 05-27-2023, 07:29 PM   #12
Kall
Not Yet Wild
 
Join Date: May 2023
Posts: 2
Default Re: Cheap 420 cc engines

New member, Iím looking for some information on what the belt tension is supposed to be. I was told about 2 inches I have about 2 1/16 right now and if I pull or spin the secondary clutch, the belt spins pretty easily around the drive clutch. I have a 780 Style drive clutch with a stock secondary that I machined a 3/16 spacer. To allow for the 1-3/16 belt to not kick off. It is a Duramax 440 cc swapped club car DS 2011 model. I hoping that itís something to do with the belt tension. I had tested this whole set up running the stock carburetor and very worn out secondary that I tossed a piece of schedule 40 pipe in so the belt wouldnít kick out. I was debating on doing the jack shaft and flipping the motor around after I figured out the reverse rotation problem with the 97 club car DS. First I wanted to make sure I was at least achieving stock speed before I bothered. With that test configurations and I achieved 15 mph in my 16:1 now forward gear. Since that initial test phase, Iíve wrapped everything up, I put in Mikuni style carburetor with a custom-made intake, so I can pull vacuum line to run the fuel pump, Iíve got a brand new secondary with a red nondirectional spring. I was told to do the spring because Iím now spinning the clutch the opposite way. After doing all of this Iím only getting up to 12 mph in forward gear. What is sad is that I can reach 18 to 20 mph in reverse. Anyway, most importantly, I need to lock down this belt tension. Itís weird because they have to be just right, the Goldilocks zone, not to lose not too tight.
Kall is offline   Reply With Quote
Reply
Go Back   Buggies Gone Wild Golf Cart Forum > Modified Golf Carts > Big Block Talk! > Clone Engine Swaps


Thread Tools
Display Modes


Similar Threads
Thread Forum
WTB cheap 36V-48V motor and controller CHEAP! Central Washington Golf Carts and Parts
engines Golf Carts and Parts
Where to buy engines Gas EZGO
Engines?? Gas Club Car
New 350 cc MCI engines Available!!!! Gas EZGO


All times are GMT -5. The time now is 05:33 PM.


Club Car Electric | EZGO Electric | Lifted Golf Carts | Gas EZGO | Used Golf Carts and Parts

Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2023, vBulletin Solutions, Inc.
This Website and forum is the property of Buggiesgonewild.com. No material may be taken or duplicated in part or full without prior written consent of the owners of buggiesgonewild.com. © 2006-2017 Buggiesgonewild.com. All rights reserved.