Part identification

[Michealmyers]

Wheel bent in today and looks like this piece is the culprit. Any clue what it’s called and where to get one ?

[Michealmyers]

Is this the right one

American Star CMR 12 3/4 x 3/4-16 RH Thread Male Heim Joint Rod End (Set of 2 with Jam Nuts) https://www.amazon.com/dp/B071WSK6R8...YK6SACG0XBPR2N

[sthreatt]

I'm pretty sure that's not it. The one you need was part of an aftermarket lift kit. I've installed several of those and I'm pretty sure they're nowhere near as big as that in the link you posted. It say's 3/4" right hand thread stud and 3/4" bore. I think what you're looking for is closer to 1/2" in size. Screw the broke off stud out of the swing arm and measure the stud size and threads per inch. I think it's going to be maybe 1/2 by 20 thread. If so, they're on Amazon too.

[Michealmyers]

Think this might be it. It’s a mjfx kit so maybe this is the one?



https://www.jasonsgolfcarts.com/Madj..._p/r16-8-3.htm

[sthreatt]

Originally Posted by Michealmyers

Think this might be it. It’s a mjfx kit so maybe this is the one?



https://www.jasonsgolfcarts.com/Madj..._p/r16-8-3.htm

If you knew for sure that your lift kit was a Madjax brand, then I'd say yea, that's probably it. Does the kit on your cart have Madjax markings ? If your lift kit was a cheaper Chinese knock off, then it may or may not be the right part. If your kit is marked Madjax, then yes, thats probably right.

[Michealmyers]

Yes it has the markings. Anyone know how you get the joint off?

[sthreatt]

Originally Posted by Michealmyers

Yes it has the markings. Anyone know how you get the joint off?

Take that bolt out with a 3/8 allen wrench.

[Michealmyers]

ok didn't realize there was an allen bolt in there.

[Michealmyers]

This is broke too any suggestions

[sthreatt]

Originally Posted by Michealmyers

This is broke too any suggestions

You're gonna need another one of those. Don't know if you can find one without replacing the lift kit.