|
12-29-2018, 09:49 PM
|
#1 |
|
Not Yet Wild
 Join Date: Sep 2011
Posts: 52
|
72 volt micro switch?
When converting a cart to 72volts is there correct way to handle throttle micro switches? I’m using a 72v main contractor and 72 volt reversing contractors. I’ve done these before on EZGO’s and had no issues . My current project is a Club Car and I’m using its M-Core. I wasn’t sure if a 72v contractor takes more current to latch than lower voltage contractors. More current has got to put a strain on the circuit board tracers in the -Core.
 |
|
|
 Today
|
|
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
|
12-30-2018, 05:32 PM
|
#2 |
|
Not Yet Wild
Join Date: Aug 2017
Location: Central Florida
Posts: 37
|
Re: 72 volt micro switch?
If resistance of the coils were the same, more voltage is more current draw/..ohms law...E=IxR
Sent from my iPhone using Tapatalk |
|
|
|
|
01-04-2019, 09:23 PM
|
#3 |
|
Not Yet Wild
Join Date: Sep 2011
Posts: 52
|
Re: 72 volt micro switch?
I understand but is there anyway of know if the circuit board tracers or the micro switch in the MCore will handle the increase?
Sent from my iPhone using Tapatalk |
|
|
|
|
01-21-2019, 02:42 PM
|
#4 |
|
Not Yet Wild
Join Date: Aug 2018
Posts: 46
|
Re: 72 volt micro switch?
I don't know if this helps you or not , but the matsushita contactors I am using on my 72v conversion (gas filled) pull 4/10th of a amp on the 12v coil circuit
|
|
|
|
 |
|
||||||
|
|
Similar Threads
|
||||
| Thread | Forum | |||
| Series F/R switch micro switch wiring? | Electric EZGO | |||
| 95 DS 48 volt micro switch 3 question | Electric Club Car | |||
| 2002 txt 36 volt series cart keeps blowing micro switch | Electric EZGO | |||
| Micro Switch issue or F & R switch. | Electric EZGO | |||
| 1996 48 volt won't run - solenoid or micro switch | Electric Club Car | |||
Linear Mode
