Cart goes 10 feet and stops

[Whatcop?]

Originally Posted by mjroman20

Try this then, with the cart in neutral, tow/run on, key on. Push the cart by hand. It should roll a foot or so then become difficult to move. At this point the reverse buzzer should go off. If not, then you may have a speed sensor issue.

Functions as it should.


So I jacked up the rear and reset the OBC according to the sticky. I'm sitting in the cart now and if I just hold on the gas after a bit sometimes the solenoid will click and cart will come alive. It stays running steady as long as I'm not bouncing it off the speed limiter. If I let go sometimes I can bring it back to life and other times I have to wait.

[Whatcop?]

Originally Posted by TahoeDawgZ71

I'm thinking it's an MCOR issue. Locate the MCOR beneath the floorboard on the passenger side of the cart. Do not mess with the triangle 3-pin connector. Un-plug the two pin square plug from the MCOR and make a jumper out of a paperclip or a small piece of wire. Jump the two pins together within the connector. If the cart operates normally, you'll need to order an MCOR4 conversion kit, part number AM293101

It appears we have a winner

[scottyb]

T Dawg

[jjance]

I'll bet Dave orders those MCOR's by the trailer truck load full. :)

[TahoeDawgZ71]

Originally Posted by jjance

I'll bet Dave orders those MCOR's by the trailer truck load full. :)

15 at a time, once a week.

[TahoeDawgZ71]

Originally Posted by Whatcop?

It appears we have a winner

I lied to you. I told you I'd ship it tomorrow. I actually had a chance to drop it off today. You should see it tomorrow.

[Htownblue]

Originally Posted by TahoeDawgZ71

I lied to you. I told you I'd ship it tomorrow. I actually had a chance to drop it off today. You should see it tomorrow.

Service and knowledge are two reasons this guy is very successful. Boom. TahoeDog for the win again.

[Whatcop?]

Originally Posted by TahoeDawgZ71

I lied to you. I told you I'd ship it tomorrow. I actually had a chance to drop it off today. You should see it tomorrow.

Thanks for the help and parts bro

[TahoeDawgZ71]

Originally Posted by Whatcop?

Thanks for the help and parts bro

You're welcome.

[scottyb]

In my opinion based upon what I know and what I just read, MCOR failure is a problem of epidemic proportions.