|
Electric Club Car Electric DS, and Precedent golf cars |
|
Thread Tools | Display Modes |
09-29-2021, 04:54 PM | #1 |
Not Yet Wild
Join Date: Aug 2021
Location: GA
Posts: 7
|
Alltrax SR48400 code Throttle range error
I finally got the computer hooked up to my 48VDC club car DC. with an Alltrax SR48400. I'm getting a Throttle range error with low battery. I am charging batteries now. I got this cart with no wires and have gone off the Alltrax diagram to wire everything back to their specks. please help.
Thank you |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
09-29-2021, 05:47 PM | #2 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Alltrax SR48400 code Throttle range error
We need to first determine, what type of throttle does the cart have?
V-glide multi-step pot? Pot box under the floor? MCOR? PB6? Then need to make sure the alltrax is set properly. |
09-30-2021, 06:48 PM | #3 |
Not Yet Wild
Join Date: Aug 2021
Location: GA
Posts: 7
|
Re: Alltrax SR48400 code Throttle range error
it is at v-glide with 4 wires blue, greem with white stripe, gray and white
|
10-01-2021, 04:45 PM | #4 |
Not Yet Wild
Join Date: Aug 2021
Location: GA
Posts: 7
|
Re: Alltrax SR48400 code Throttle range error
so after letting it sit for a day I hooked up the laptop again i get a quick flash of shutdown, overcurrent and throttle range error. then after a second it will keep just the throttle range error.
|
10-04-2021, 09:36 AM | #5 |
Not Yet Wild
Join Date: Aug 2021
Location: Florida
Posts: 63
|
Re: Alltrax SR48400 code Throttle range error
You may have already don’t this, but call Alltrax and go through the entire setup process with them. They’ll tell you the proper ranges. It could just be a programming issue.
|
10-04-2021, 04:31 PM | #6 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Alltrax SR48400 code Throttle range error
Then depending how you have the wires hooked up at the V-glide and at controller it will either be a 0-5k or a 5k-0 throttle.
Make sure you have the rear wheels of the cart off the ground for testing. Set the throttle type to one of those in the toolkit and see how it responds. |
10-05-2021, 11:47 AM | #7 | |
Gone Wild
Join Date: Sep 2014
Location: Orlando, FL
Posts: 1,308
|
Re: Alltrax SR48400 code Throttle range error
Quote:
|
|
10-22-2021, 05:09 PM | #8 |
Not Yet Wild
Join Date: Aug 2021
Location: GA
Posts: 7
|
Re: Alltrax SR48400 code Throttle range error
it turned out to be the solenoid was not open all the way. got a HD and started to work 2 days ago. thanks for the trouble shooting with alltrax. Now i think I need new batteries. I get great speed and torque for a about 30 min on a full charge. then they start to die out voltage will drop to 32 volts going up the hill then back to 47 when going down a hill. It is also taking over 12 hours to charge. I'm using stock charger with Powertrorn P8000. I have checked the connections and used dielectric grease. using 48 step down transformers so I dont pull too much off one cell.
tested each battery 8.26 to 8.29 VDC. maybe need bigger cables or battery is just not holding amps..... |
10-22-2021, 07:23 PM | #9 |
Bonafide Nincompoop
Join Date: Dec 2015
Location: Charlottesburg Va
Posts: 8,987
|
Re: Alltrax SR48400 code Throttle range error
Those batteries are about toast. Dropping to anything under 40v under load is really hard on the batteries and electronics. Lower voltage means higher amp draw and will cause stuff to burn out. Can also cause battery cables or terminals to overheat and burn.
Should have about 8.49v per battery on a full charge. Total pack voltage should be 50.9 or better, 12 hours rest after a full charge. Use an SOC chart and don't run the pack below 50% SOC voltage to get the best lifespan from new batteries. |
10-26-2021, 04:28 PM | #10 |
Not Yet Wild
Join Date: Aug 2021
Location: GA
Posts: 7
|
Re: Alltrax SR48400 code Throttle range error
got new batteries and played with the v glide some more runs awesome. clocked 17 up hill and about 25-27 flat land. thank for all the help.
|
Tags |
#alltrax, #sr48400 |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
Bombardier NEV throttle out - error code 1-4 | Electric golf carts | |||
Alltrax error code | Electric EZGO | |||
alltrax error code high throttle input underrange | Electric Club Car | |||
Alltrax SR error flag, High Throttle Input Under-range | Electric Club Car | |||
Alltrax SPM "low throttle" error code | Electric EZGO |