Can't get the solenoid to engage

[MAD-DOG]

Her is the Vin of the cart and it does have a run tow switch . If I ground out the small black terminal I can get it to click . But cart still won't move looking for some troubleshooting procedures I do have 48 volts at the run tow switch. And the reverse buzzer has been removed so that's no help

[cgtech]

2009 drive electric. Put something (volt meter) to the reverse beeper plug, or get a beeper. Check fuses in harness by rain gutter, or at rear of seat bottom, or under rear access cover. If all fuses are good, power in & out of tow/run, BUT no power to reverse beeper port (under nose) when in reverse, or power all the time (even when not in reverse) , is a usually indication of failed controller. If you try all this, and it still gets you nowhere, i will dig up more wiring info, but the reverse beeper doing anything unusual, and no solenoid click (when tow/run is good) is usually controller. Solenoid & reverse beeper are operated by controller outputs. The solenoid should click on then off when tow/run is flipped to run (that not happening is another bad sign for controller).

[MAD-DOG]

10-4 I'm ordering I controller today thanks