|
|
Thread Tools | Display Modes |
04-08-2019, 09:53 PM | #1 |
Not Yet Wild
Join Date: Apr 2019
Posts: 3
|
Chassis recommendation for 52v li-ion conversion and project reality check
Hi buggie fanatics,
I do a lot of e-bike conversions and now I have my eye on converting a golf cart. Unfortunately, there aren't nearly as many resources online for li-ion conversions in the golf cart space as there is in the bike world. I'm looking for a used 48v cart and could use some advice for what model I should buy. I happen to already have some 52v li-ion batteries and want to use them for the conversion. It's totally flat where I live, I don't need more than 10 miles of range, and don't need to go faster than 20mph. The cart will be used to move the kids around the neighborhood and that's about it. My 52v batteries will put out 40amps continuous and have about a 28ah capacity. I know that's not much compared to some of the li-ion cart conversions out there but my power needs are very modest and I already own the batteries and chargers. My hope is that I'd be able to find a used 48v four seat golf cart with dead batteries and that my 52v li-ion battery would serve as a mostly plug and play substitute. If I have to replace controllers and motors, this doesn't make sense for me. Can any of you see any reason I can't just swap out the old batteries with my li-ions without having to redo all the electronics? Do I need to worry about being slightly over-volted? Thanks! |
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
04-09-2019, 04:19 AM | #2 | |
Gone Wild
Join Date: Jul 2018
Location: Central Ohio
Posts: 1,720
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
Quote:
Oh, and welcome to the forum |
|
04-09-2019, 05:26 AM | #3 |
Gone Wild
Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,204
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
As the Alltrax Tech told me when I ask the question of "Flooded batteries" vs "Lithium batteries" he said "Power is power no matter what the source."
So, if the standard (factory) controller can "take" the 52-V (I've read a few post where the factory controllers cannot support 57-V....the controller shuts down) you should have no problems using your lithium batteries. Of course, amp\hr is still going to be a consideration even if you're just driving over flat terrain. You don't state the brand of lithium batteries you're using (or if you're also using a Battery Management System = BMS) or the total amp\hr your battery pack will have. You don't want to do the switch only to find out you have a 2 mile run time. |
04-09-2019, 09:22 AM | #4 |
Not Yet Wild
Join Date: Apr 2019
Posts: 3
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
Thank you for the warm welcome. I've seen the posts about the Leaf and Volt batteries but as far as I've been able to find, they don't generally address overvolting and any use case for lower amps. I'm having trouble find spec sheets for the typical controllers found in electric carts and their voltage tolerance. Good to hear a little extra voltage doesn't seem to cause too much trouble. With the lower current, i'm guessing it will be even less of an issue.
My batteries are custom made from Panasonic li-ion cells and already have a bluetooth BMS built in that allows me to remotely monitor cell voltage and temperature. I have a few thousand watt hours available for capacity but only 40amp continuous current. |
04-09-2019, 11:01 AM | #5 |
Just Gone
Join Date: Sep 2015
Location: North Carolina
Posts: 3,549
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
Carts can pull big amps and I don't think 40a continuous will cut it. My cart can cruise on a fairly flat surface and pull more than 40 amp continuous. So that 28ah pack won't last you long at all.
|
04-09-2019, 12:30 PM | #6 |
Not Yet Wild
Join Date: Apr 2019
Posts: 3
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
That's good to know, thanks. I only need a few miles range but if you are pulling 40amps on level ground, looks like I'm going to need more power.
|
04-09-2019, 12:44 PM | #7 |
Gone Wild
Join Date: Oct 2012
Location: Southwestern Pa.
Posts: 6,204
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
True what NCPW has stated. My cart will pull about 120amps on a "reasonable" flat smooth terrain. On steep hills is close to 400.
|
04-15-2019, 01:30 PM | #8 |
Not Yet Wild
Join Date: Aug 2018
Posts: 46
|
Re: Chassis recommendation for 52v li-ion conversion and project reality check
Can always buy a dirt cheap 36v coil cart with bad batteries and no charger put 3 cheap 12v batts in it for take off and low speed cruising, use your lithuim pack for full speed 35 amp draw ground covering . .then if you ever feel like showing off without the kids in tow you can switch to series wiring the fla and lithium packs "lithium boost" style and have a little fun
Be safe though of course |
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
48v Conversion Check List | Electric EZGO | |||
Reality check | Electric EZGO | |||
PRICE CHECK....What's this project worth?? | Electric EZGO | |||
Precedent Stereo Project - check me please | Members Rides |