Club Car V-glide, F&R, & Solenoid 4 $100

[scottyb]

1989 stock complete V-glide set up; with the solenoid and F&R switch. These parts are out of my personal cart. I am converting to a controller as part of a frame up restoration... They have been tested on 48v for 1 year. They look good and function well. They will work on 36 volts or 48 volts. Of course the solenoid is recommended for no more than 36v but, it has been tested on 48v for some time. Anyway, everything listed for $100 plus $10.00 shipping to any lower 48 state. Thanks for looking
Okay, okay... $15 more & I'll throw in the resistor coils and cables and mounting plate too. Now you have everything you need here to upgrade your 5 solenoid cart to the next generation resistor cart. (Now...from here 48v is easy) That is $125 to convert to resistor cart from 5 solenoid - delivered!

[justbrew77]

how difficult would this be to install in a 5 solenoid cart? would I need anything else?

[scottyb]

I could do it in under an hour easy, no rushing around. I could give everything you need including the heatshield...With wiring diagram and pictures of it installed? The only thing that would make it any easier...would be if I could come over and put it in. LOL
A guy would have to have some mechanical ability and common tools. And an ability to read or follow a wiring diagram or a helper who can would be an asset as well.

[scottyb]

If you had any trouble hooking it up there are 3,000 cart enthusiasts here who can help ! That is better support than you will find anywhere else!
Let me know .... before I throw it on ebay .....

[justbrew77]

I have to tear my cart down to paint so I might as well do this too. Will this make my cart more reliable? I was looking at getting 5 new solenoids anyway and this cost about the same. Do you take paypal?

[scottyb]

Honestly they can both be reliable if the components are not old and everything is clean and tight (maintained well). That being said...the resistor system is alot more simple. It has 2 micro switches, one solenoid, a V-glide (speed selector), and a bank of resistor coils. It replaced the earlier 5 solenoid, 6 micro switches (?+-) and a bank of resistor coils.... The V-glide is a nice in a box type speed wiper board. It is fail safe and bomb proof in my opinion....and rebuild-able, parts are very available. I have seen these systems on 48v for a year without failure...So how will it do on 36? Probably go forever with a bit of care!
PM me if you are interested .....

[scottyb]

I'll take silence as a NO.
I guess I will offer this on ebay.....thanks for looking.

[justbrew77]

I sent you a PM on Sat morning, I ended up getting some free used solenoids from a local cart shop. Sorry about that, if I wouldn't have found those I would have picked this up from you. Sorry and thanks for the offer

[scottyb]

No worries! I'm all for free stuff good luck

[scottyb]

Sold. Thank You!