03-15-2020, 07:33 PM | #1 |
Not Yet Wild
Join Date: Aug 2015
Posts: 27
|
Stuck motor spline, what worked for me.
I have a 2004 precedent I recently converted to lithium ion. In my testing of the new system I got a high reading on the back motor bearing. So I decided to pull the motor and side and service them since I have only had the cart about a month and don't know the service history. Well to make a long shorter my motor was stuck to the spline which is not uncommon according to my local cart shop.i tried every trick I could find online and none of them worked. What I finally did was pull the motor case off leaving the rotor. I then drilled and tapped a hole in the end of the motor shaft. I turned the axle up on end on a concrete block with a safety rope (turned the brake drum around and bolted it back on) screwed a bolt in the hole and hooked a slide hammer to it. Third smack and it fell off into my lap.
|
Today | |
Sponsored Links
__________________
This advertising will not be shown in this way to registered members. Register your free account today and become a member on Buggies Gone Wild Golf Cart Forum |
|
03-16-2020, 04:10 PM | #2 |
Gone Wild
Join Date: Apr 2017
Location: SE TN
Posts: 2,217
|
Re: Stuck motor spline, what worked for me.
Sounds like you just reinvented the wheel.
|
03-19-2020, 02:33 PM | #4 |
Not Yet Wild
Join Date: Aug 2015
Posts: 27
|
Re: Stuck motor spline, what worked for me.
Yea, tried that. Didn't work. The first thing I came across on the web.
|
03-19-2020, 02:40 PM | #5 |
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: Stuck motor spline, what worked for me.
|
03-19-2020, 02:49 PM | #6 |
Not Yet Wild
Join Date: Aug 2015
Posts: 27
|
Re: Stuck motor spline, what worked for me.
Well that method cost me a new set of brushes, and the back bearing holder, the only thing holding the outside of the motor to the rotor was v shaped. One more drop and I would have had to find that part too. If it works for you fantastic. I prefer the slide hammer.
|
03-19-2020, 02:56 PM | #7 | |
......................
Join Date: Apr 2009
Location: FT Lauderdale FL.
Posts: 16,416
|
Re: Stuck motor spline, what worked for me.
Quote:
|
|
|
Thread Tools | |
Display Modes | |
|
Similar Threads | ||||
Thread | Forum | |||
anyone put a 10 spline spicer rear to 19 spline amd motor | Electric EZGO | |||
Motor armature stuck on spline - removal question | Electric EZGO | |||
Club Car 1999 36 volt / armature stuck on spline | Electric Club Car | |||
rebuilt motor worked great for 3 mouths now nothing. | Gas EZGO | |||
16 spline motor | Electric Club Car |