View Single Post
Old 04-07-2019, 01:35 PM   #9
WalterM6
Gone Wild
 
WalterM6's Avatar
Club Car
 
Join Date: Apr 2017
Location: SE TN
Posts: 2,218
Default Re: DPI charger for 48 volt

Quote:
I have know idea how to test that???
First make a drawing of how it's wired up. Then get your ohmmeter out. Disconnect all wires from the bridge diode. Connect the meter between any two adjutant connections. One direction you should read open. Reverse the leads and you should read some resistance. Repeat for the other 3 diodes by selecting two more adjutant connections. Replace if any section reads the same in both directions either open or shorted.
WalterM6 is offline   Reply With Quote