Re: InfiniteReality's '99 Lowered EZGO TXT Build
Not much accomplished in the shop other than marking and drilling holes thru the new bagwell liner for some grommets. Attempting to keep it tidy for the wires and front/rear tubing runs to the manifold.
Hole for the wires is large enough to fit a waterproof harness through for the 4 solenoids. Pressure sensors have their own smaller waterproof plugs. This allow me to disconnect the entire subfloor and remove when I pull the body again.
Got sidetracked with the brass fittings with the wire wheel on the bench grinder. For some reason felt the need to clean them up.
1/8" NPT elbow is due in today, wanted to kick the tanks pressure switch 90deg like rest of it so wouldn't stick up like a sore thumb..
Hope to see the rear body on this weekend if have enough spare time.
|