Buggies Gone Wild Golf Cart Forum - View Single Post - Curtis 1204-402 Controller Conversion Problems

Roxyflash · 10-02-2016, 10:59 AM

Sounds like the motor was the culprit melting the v glide drawing too many amps.Now you replaced acouple studs could have damaged the motor.if the b+ had good voltage on a load the M has low voltage and the controller was rebuilt makes me think the motor is drawing too amps.i would try to get a amp draw off the m wire eith a clamp on amp meter see whats it drawing.i have a used motor and rear end for the cart sell it cheap

10-02-2016, 10:59 AM	#2
Roxyflash Gone Wild Join Date: Feb 2015 Location: Quad cities Posts: 334	Re: Curtis 1204-402 Controller Conversion Problems Sounds like the motor was the culprit melting the v glide drawing too many amps.Now you replaced acouple studs could have damaged the motor.if the b+ had good voltage on a load the M has low voltage and the controller was rebuilt makes me think the motor is drawing too amps.i would try to get a amp draw off the m wire eith a clamp on amp meter see whats it drawing.i have a used motor and rear end for the cart sell it cheap