I put together a cable as instructed in this thread using the same parts
https://buggiesgonewild.com/showthre...22+programming. All I get is red blinking com light and this popup "Drive or Program updated, need to reload this viewer:" that will not go away. I set the baud to 38400 on the port in device manager and changed the jumper to 5v. Drivers were installed automatically when I plugged in the device. I tried the manual driver install from another thread as well. Device shows normally in device manager. I have a 450A controller if that makes any difference and verified I do in fact have the newer 2022 controller, not the NEOS controller. Any thoughts?