Quote:
Originally Posted by BobInDaytona
Attached are a couple of pictures of the cable I made.
One shows the pinout on the device, one shows the end of the cable, and one
is a hand drawing of which wire goes to which pin - the labels rx,tx,vcc,gnd match the labels on the circuit board on the device.
The 4 pin ribbon cable that is attached to the device comes with it...
This is the same molex connector that is used on the NEOS cable.
|
If you get a copy of the software I (and others) would love to take a look at it. I'd try decompiling it and seeing if I could reverse engineer anything.
Being that it's serial and potentially some Chinese controller...I suspect it's written in C/C++ and may have some odd assemblies that might be difficult to reverse engineer but I doubt it has any sort of brute force password protection...but maybe?
Great info though!!