Re: Wiring Alltrax for reverse with single micro-switch F&R switch...
David Hicks straightened me out. I was under the assumption that the pin on the controller had to get a signal but apparently that's only if you want 1/2 speed reverse. We will try it out with full speed reverse and if we want to adjust it I will look into it more. I was wondering about using the buzzer signal but I haven't checked to see what the voltage it gets is yet. After a quick look yesterday I didn't get a good feel for the buzzer wiring, one wire goes to the back of the charge socket and one wire goes to the solenoid so I am a bit confused how that gets triggered.
|