Quote:
Originally Posted by DAVID146
I have a ezgo dcs system that want go. The solnoid clicks but it will not go. I just put new batteries in 36v. My MOM said that she had to push it home but tought the batteries were gone because all of them were leaking. I looked up the wireing diagram to be sure that it was wired right. 36V on batteries where do i start?
|
Start by charging the batteries. 36V is lower than the batteries should ever be allowed to discharge.
A fully charged 36V battery pack reads 38.20V and a fully charged 6V battery reads 6.37V.
New batteries should be fully charged prior to first use and then recharged after each time the cart is used.
For proper battery care, go to this website and read everything with the word "Battery" in the title.
http://www.cartsunlimited.net/Batter...n_Methods.html
---------------
Scottyb already asked if Run/Tow switch was put into Tow when the cart was pushed home, but along that same line, was the switch in Tow when the batteries were replaced?
Where did the batteries leaking from?
Do you have a digital Voltmeter?