Re: Old EZ - GO WONT MOVE
hello all,
I have a feeling the problem is in the pedal switch..
There is a red and green wire hooked to pedal switch..
I have 32.5V at the red wire, BUT I got -00.7 on the green wire...
Pedal pushed in or not... I am thinking when pedal is pushed the volts should go to the green wire..
I am thinking red is in and the green is out... Is this correct?
I am not very good with electrical, So bare with me here... If it was gas it would not be a problem.HEHE
I think the micron switch is bad..
Ant...
|