View Single Post
Old 11-26-2019, 10:28 AM   #1
Wasga
Not Yet Wild
 
Join Date: Jun 2017
Posts: 6
Default EzGo Workhorse only runs up to 1/2 throttle then boggs.

I have an EzGo workhorse with the robin eh35c engine. It will run fine at less than half throttle, but if you press more it will start to bog down. Let me tell you what i have done already. It has a new carburetor and is getting fuel from the fuel pump. I adjusted valves to specifications. (.004) I have done the HEI conversion, new coil and new pickup coil. I checked the timing belt to make sure it was in time. I have 175# compression on both cylinders. I am stumped with this thing. Does anyone have any input?
Wasga is offline   Reply With Quote