Buggies Gone Wild Golf Cart Forum - View Single Post

OLD MEC · 05-21-2011, 04:52 PM

The bolt that goes through center of front spring has a offset to adjust camber. To check alignment you need a carpenters square ( large type ) find a flat surface and roll cart back about 10' and roll forward while holding steering wheel straight. Then place carpenters square ( long side ) against tire sidewall and there should be 1/4" to 1/2" clearance on bottom sidewall. To adjust loosen the 4 bolts that hold spring and plate against frame and then loosen spring center bolt nut and this allows spring bolt offset to move from one side to the other for alignment.

05-21-2011, 04:52 PM	#2
OLD MEC Gone Wild Join Date: Mar 2009 Location: South Texas Posts: 2,391	Re: Problem with handling The bolt that goes through center of front spring has a offset to adjust camber. To check alignment you need a carpenters square ( large type ) find a flat surface and roll cart back about 10' and roll forward while holding steering wheel straight. Then place carpenters square ( long side ) against tire sidewall and there should be 1/4" to 1/2" clearance on bottom sidewall. To adjust loosen the 4 bolts that hold spring and plate against frame and then loosen spring center bolt nut and this allows spring bolt offset to move from one side to the other for alignment.