Quote:
Originally Posted by kingcobra
johnnie thanks for the info your right on the m- post my bad I am placing the black probe from my tester on the far left controller post and the red on each corresponding post to get my readings Im no electrical expert by any means I am assuming the black probe from my meter is for grounding? and the red for current? I did notice the two leads m- and b- from my controller run back to the motor so obvious no go with no voltage I am wondering if I am using my meter correctly for each reading any thing you can glean from this info?
|
What is the "far left" terminal on your controller labeled??????????????????
The word "Left" doesn't tell me a darn thing because it could mean driver's side or passenger's side of cart depending on which way one is facing.
The black test lead should be connected to B-, either as shown in the attached drawing or the controller terminal labeled B-.
If the cables attached to M- and B- both run to the motor, your cart is wired wrong!!!!!!!!!!!
M- attaches to A1 terminal on motor, but B- should attach to negative terminal on right-rear battery as shown on drawing.