[dbmw281]

Ok here we go; I cleaned all connections on the motor and F/R and have good readings on the F/R and continuity on the motor from A1 to A2 and S1 to S2. My micro switch which has an orange wire going to the solenoid and a blue one to the controller seams to be working with sending power to the solenoid. I tested the ohms on the speed controller/pot (is the speed controller as some people call it the same as the pot) and it seams to be all over the place. I have a curtis 275A controller and the pot or speed controller under the micro has four wires coming off it with 2 going to the controller and two going to the double micro behind the F/R. If this is what seems to be bad, could i get the pot with the micro switch built in or which pot should i get. I appreciate any help or suggestions from anyone