Re: 2012 RXV brake problem - Curtis Controller
Your Run Plug socket is totally missing! Why would someone cut it out like that? At least with the Curtis Controller, it's not used for the CAN Bus in a 2012, but in later years (2014 on) Curtis resumed use of the CAN Bus for communications with a GPS system. It looks like you are missing the wire that connects the motor brake to the controllers motor brake sense wire. That splits off of the Run Plug socket and connects to the controller so that it can sense the state of the motor brake. Without that wire, the controller will not pass its poweron testing. Where are you located? There is a way to disable that test in the controller, but it requires an OEM or higher level programmer to do it.
I'll see if I can get some pictures of the Run Plug socket and a Run Plug for you later.
Bob
|