Buggies Gone Wild Golf Cart Forum - View Single Post - 1999 CLub car w/ new controller not working

OLD MEC · 09-25-2010, 07:01 PM

Need complete serial number from under passenger glove box. Was old controller working before change over and could it be new-used unit is defective? If solenoid clicks each time pedal is pressed try jumer cabel of 6 gauge or close wire across both large terminals on solenoid, BUT BEFORE TESTING DO FOLLOWING
Jack up wheels off ground, place auto type jack stands under axle round housings, block front wheels in both directions. WARNING ONLY RUN MOTOR FOR FEW SECONDS so keep from throwing pieces around when motor blows from high RPM.
What main control box are you talking about? Possibly OBC with 6 guage cable running through middle? If so only make charger work and has nothing directly to do with cart movements.

09-25-2010, 07:01 PM	#2
OLD MEC Gone Wild Join Date: Mar 2009 Location: South Texas Posts: 2,391	Re: 1999 CLub car w/ new controller not working Need complete serial number from under passenger glove box. Was old controller working before change over and could it be new-used unit is defective? If solenoid clicks each time pedal is pressed try jumer cabel of 6 gauge or close wire across both large terminals on solenoid, BUT BEFORE TESTING DO FOLLOWING Jack up wheels off ground, place auto type jack stands under axle round housings, block front wheels in both directions. WARNING ONLY RUN MOTOR FOR FEW SECONDS so keep from throwing pieces around when motor blows from high RPM. What main control box are you talking about? Possibly OBC with 6 guage cable running through middle? If so only make charger work and has nothing directly to do with cart movements.