[scmoose]

Tried to save a few bucks and make my own personality switch for my Alltrax 300 but not having any luck. I've built the switch using the drawing found on this sight with just three wires going from a plug that fits the J4,5,and 6 connector going to a three position, three pin switch. I've got the profiles saved in the tool kit, however no matter what position I have the switch in, it only runs in the "user" mode, which I have set to run the cart fast. In the tool kit under the monitor tab, I see user 1, 2, and 3. If I put the switch in what I think is the user profile position, the user 3 dot shows high lighted in the monitor tab, any other position of the switch high lights all three user buttons in the monitor tab. Hope my description makes sense. I do have the program in dual switch in the tool kit as well.