Re: Club Car TRX Fab
I didn't want everything hanging off what little of the original frame I had left so I decided to fab up some brackets and also bolt it to to the top of the cart frame into holes that were already on the ClubCar. That would provide a lot of extra strength as it formed a triangular brace.
I had to extend the TRX frame a a few inches to reach the new plate because I made a mistake earlier and cut too much off - humph — ROOKIE! The "Dots" you see are from me inserting a smaller square tube into the TRX frame. Drilling holes and welding that smaller tube to the frame for more strength. I did this on all four sides of the extension in different places.
|