Re: 97 CC 48v not running
On a Gen 1 controller (without a bypassed main solenoid), the controller powers-up the main solenoid and you would hear a distinct CLICK. If you remove that solenoid jumper, test the small gauge wires for 48v when you turn the key switch. If there is 48v when you turn the key - then a prior owner bypassed a failed solenoid (bad idea - it's a safety thing).
More likely there is no voltage on the small wires when you turn the key; and that tells you that your controller has already had a partial failure of one of it's primary functions.
The above statement assumes that the bypassed solenoid is the one WITHOUT the coiled wire resistor...correct?
|