[Spudgunman]

one tip I have is that if your cart is from a fleet used or simply havent done this.

pull the plastic rivets out of the floor mat and take care to remove it - specially around the break and gas (the mat will rip easy)

once removed simply lift out the access panel and you will likely see a lot of trash and mud - clean all this out. then spray some silicone lubricant or wd-40 to eliminate water in this area on the mechanical parts.

while your down here examine the area for any damage or wear.

Also take note of the switches you can use or modify to stop the reverse beep, add light's etc.