Quote:
Originally Posted by Geauxtigers
05 club car ds IQ
installed the new alltrax dcx 400 controller and solenoid today!!!
1----charger will not kick on at all nor does the needle move on charger at all
checked the fuse and diode behind the receptacle on cart and they are both good
I have a power drive two charger
I have around 49 volts on batteries
2----and only one tire moves on the cart while in forward and reverse (drivers side)
is this normal for only one tire to turn???
3----also the 4 pin plug going to the bottom of the F&R has no place to plug on new controller (im guessing I dont need it???)
thanks
|
1.) There are three cart-side fuses. Two glass ones in the yellow cases. One by the charge port, and one by the OBC. The third is the one on the charge port itself. There is also a fuse on the charger inside the glass cover. Make sure all fuses are in good order. Also make sure the circuit breaker on the charger is not tripped
2.) That is normal operation. These have an "open" differential
3.) The Alltrax does not utilize programming access through the 4-pin connector. That is not used. On the Alltrax controllers, it is under the black round cover on the controller itself