Re: Throttle/Pedal Issues 2012 PH Series Precedent
Those values look normal for an MCOR3.
It may be an issue with that repaired Controller.
Unless You have an IQDM type Curtis programmer, it will be hard to diagnose much further.
Without an IQDM, the only way to measure the throttle signal is to get a reading on the Yellow wire (Pin #2) at the Controller 16-pin connector, with everything connected, FNR in neutral and key switch ON.
It should vary from 0.35v to 4.65v (approximately) from Pedal Up to Pedal down.
Perhaps other folks have some ideas.
|