Precedent I2 Excel MCOR 2 replacement
Just to double check before I spend the $$$ for a new MCOR 4 and conversion kit.
The cart will not move at all. Batteries fully charged and forward/reverse switch is ok. Run/tow switch is ok.
I get no ohm readings at all between any of the 3 leads from the pot. The on/off switch is functioning.
My pedals are Gen 2, so I think I only need the wiring harness plug conversions.
Is there a way to test the operation of the motor controller without the MCOR? What is the resistance of the internal pot? I have a few around if they match.
Thanks
|