Quote:
Originally Posted by Cobra,1
Nice print👍
My printers printing more flag holders that clamp to roof support to hold small American flags. Bunch of fellow campers want them for Memorial parade up camp ground😊
|
Keep it printing! The one skill I've gained that I most appreciated from this build is confidence in modeling in 3D. Was even excited when I got to make a mount for the light bar since had something new to draw. 2nd mount is printing so can test fit this evening.
Note to anyone else using front air shocks on the front. Trim the bottom of the shock cover. Couldn't figure out what was holding my shocks back from full lift, bottom of cover was catching on the shock mounts (since they're outside axle now) which stretched the front holes. Glad these light bar mounts will cover it up, although the wide flange head bolts I used covers it up already.