Quote:
Originally Posted by twilliams81
I’m doing the 500 XCT with the 400 amp solenoid..doesn’t that one only have the one diode?
Sent from my iPhone using Tapatalk
|
Look at the install diagram in your owners manual. It shows 2 diodes that need to be installed. One is small and short and fits between the 2 small posts on the solenoid (as shown in the manual). Polarity is critical. The stripe on the diode indicates the + end. When installed this end needs to towards the + wire also shown in the install diagram.
The second diode is larger... it comes with every Ezgo and CC XCT controller with instructions to put it on the large terminals. In this application the striped end (+) goes toward the post with the main positive battery cable attached.
I hope this helps