View Single Post
Old 06-13-2019, 07:59 AM   #1
Jeverall
Not Yet Wild
 
Join Date: Jun 2019
Posts: 44
Default Personality chip in my 08' 48v 6 seat ezgo shuttle?

I purchased one of the $6 "personality chips" or speed chip off of Amazon. My cart is avg 12-14MPH so I was hoping for a little more speed. I watched the installation instructions on youtube and it looked pretty easy. However when I lift my middle seat up, the Tow/Run switch is on a simple thin panel and does not appear to be integrated into the motor or controller like the videos on youtube. My cart has the Fwd/Rev on the dash. Is the component I am looking for under the dash (rather then below the seat) of my cart? If so, is taking the dash apart going to be a worthy endeavor for this "modification" or should I just pass?
Jeverall is offline   Reply With Quote