Re: 2003 Club Car Silver Standard
I'm afraid you have gotten confusing instructions for removing the speed sensor. On that cart all you do is use a screw driver and pop it off, then unplug the wires. What you have now is a bearing retainer ring loose in your motor. The two flat head screws need to go back in to hold the motor bearing. You will need to remove the motor from the cart take the end cap off the motor so you can get screws started in the retainer. You will need a longer screw to get the first screw in place. Once you have that done you can put the end cap back and install the normal screw, once it is in you can remove the long screw and put the normal one in and the cap can be fasten back down. I know this sounds like a good reason to blow the cart up, but it's not that bad.
|