View Single Post
Old 04-06-2012, 10:24 PM   #3
jims72
Not Yet Wild
Yamaha
 
Join Date: Feb 2012
Posts: 23
Default Re: Chrysler ignition module and voltage regulator on g2

g2 pinout.jpgAttachment 64868here ya go the pins are numbered one through five in a clockwise manner. I would also like to add that you have to mount the ign module to the frame as the case is the ground. any other questions just ask i would love to help. I have been using this setup for a week now without any problems. also female bullet connectors work to connect your wire ends to the module. You can use the dual pin ballast resistor as shown here and just leave the other side open until needed.Kinda like carrying a spare,but the single pole used on chrysler ignition systems until 71 works just as well.
jims72 is offline   Reply With Quote