Quote:
Originally Posted by csmdew
I have some Gambel CG10, 10 watt, 250 ohm 6% wire-wound axial lead resistors if they would be ok. Also I'm pretty sure I will never upgrade this cart to 48volt but since the difference is only about $75 I may as well go with programmable. So the solenoids like sold at most of the cart shops are mounted with plastic case end down and battery + cable is to lug closest to batteries, blk leeds to left/batteries side and red leeds to right/cart body side. Are there any HD micro-switches that I need for the f/r switch(bought hd cam). Thanks
|
yes, that resistor would work.....
if you buy it as a programmable, either make sure its already set up for your set up, or understand how to do it. Personally, if it were me, I would buy it from ScottyB at CartsUnlimited.net and tell him your carts set up and he will pre-program it so when you get it, its ready to install and go.
the F&R micro switches are the same......so getting the cam and installing it on your switch is all you need.