Buggies Gone Wild Golf Cart Forum - View Single Post - Need to fish for the bearing retainer in a GE motor

TahoeDawgZ71 · 08-18-2016, 08:53 PM

You're not supposed to go fishing with the lid on. Take the cap off the motor and you can actually see the bearing retainer. Start both screws and bolt the cap back on. Then you'll have the retainer attached to the two screws. Remove them one at a time and start the short screws and tighten them up.

08-18-2016, 08:53 PM	#5
TahoeDawgZ71 revolutiongolfcars.com Join Date: Mar 2010 Location: Golf Car Capital of The World... Augusta, Georgia Posts: 10,224	Re: Need to fish for the bearing retainer in a GE motor You're not supposed to go fishing with the lid on. Take the cap off the motor and you can actually see the bearing retainer. Start both screws and bolt the cap back on. Then you'll have the retainer attached to the two screws. Remove them one at a time and start the short screws and tighten them up.