View Single Post
Old 07-17-2007, 08:57 AM   #1
ruredy
Born Wild
 
ruredy's Avatar
 
Join Date: Mar 2007
Location: Clover SC.
Posts: 5,552
Default EZGO 295 - 350 engine Valve Adjustment

EZGO Valve Adjustment



This post was done by ezgomike elsewhere, its such a great post I wanted to include it over here for those who missed it. Thanks Mike

Start with a cold engine(this ones at about 12 degrees for the pics).

Remove 6 valve cover bolts, and pry off cover:

EZGO Valve Cover

Clean o-ring surface(blue arrows) carefully. Do not drop dirt in any holes.
Check o-ring for damage, and make sure it is fully seated in cover(red arrows). Do this now, you'll be too excited later, and forget:


EZGO Valve adjustment

Pick a valve. Turn cam lobe DOWN by rotating drive clutch by hand(red arrow): Loosen adjuster locknut 1/4-1/2 turn.



Insert .004" feeler guage between cam, and lifter(red arrow): Turn adjuster until feeler guage has very slight drag, but is free.




Hold the adjuster with a screwdriver, and tighten lock nut as shown. Then re-check with feeler again. Now, do the same for the remaining valves. The middle two are the intakes.



Re-install cover(check the o-ring again). Tighten bolts to 5 ft/lbs.

***NOTE: No feeler gauge handy? if you lightly bottom the adjuster against the valve, then back off 1/4 turn on the adjuster, you will be very close to .005"***
ruredy is offline